slow-poke
Ultra Member
Tom was looking for clarity on scale connections to E117-00
The labels on the schematic echo those on the board.
Pin 1 = +5V (V)
Pin 2 = A
Pin 3 = B
Pin 4 = Ground (GND)
A and B can actually be swapped your DRO numbers will just go down instead of up. I would imagine there is as setting in software to reverse the direction so either method could be used.
So for your particular scales......
Scale E117-00
---------------------------
A TB6-2 A
B TB6-3 B
C TB6-1 5V
D TB6-4 Gnd
The labels on the schematic echo those on the board.
Pin 1 = +5V (V)
Pin 2 = A
Pin 3 = B
Pin 4 = Ground (GND)
A and B can actually be swapped your DRO numbers will just go down instead of up. I would imagine there is as setting in software to reverse the direction so either method could be used.
So for your particular scales......
Scale E117-00
---------------------------
A TB6-2 A
B TB6-3 B
C TB6-1 5V
D TB6-4 Gnd