Just Joined

S

Stainless201

Member
Hi everyone, I have an XLO 602 with the original paperwork I bought years ago. I found out it had a repair to the overhead gearbox which was the small gear ( originally made of bronze), this one is steel . It has blue dye on it so it's been replaced ??? The gear seems slightly not right, almost a tight spot I tried to measure or the hole center is out . I finally am retired & have more time to fix stuff. I am looking to buy that gear if anyone knows where I could find one is the best option, if not available does anyone have the correct dimensions, material, pictures etc, so I can try to have one made. I forgot to mention the gear noise changes from a clacking noise unloaded to fairly quiet noise loaded . Thanks very much, glad I joined the group & look forward to hearing back from all the experience on this site. Ron.
 
Proxule

Proxule

Ultra Member
Welcome, Loaded gears can and do sound different, especially if too much backlash exists they will slap around.
The tight spot as it rotates does indeed worry me. I do not have specs or dimensions for your gear, but others might. Perhaps even a source for the gear!

Enjoy your stay!
 
Dusty

Dusty

(Bill)
Premium Member
Welcome aboard from sunny Saskatchewan. Born in Hamilton, raised and educated in Stoney Creek.
 
S

Stainless201

Member
Proxule said:
Welcome, Loaded gears can and do sound different, especially if too much backlash exists they will slap around.
The tight spot as it rotates does indeed worry me. I do not have specs or dimensions for your gear, but others might. Perhaps even a source for the gear!

Enjoy your sta
Click to expand...

Dusty said:
Welcome aboard from sunny Saskatchewan. Born in Hamilton, raised and educated in Stoney Creek.
Click to expand...
Thanks neighbour
 
S

Stainless201

Member
Proxule said:
Welcome, Loaded gears can and do sound different, especially if too much backlash exists they will slap around.
The tight spot as it rotates does indeed worry me. I do not have specs or dimensions for your gear, but others might. Perhaps even a source for the gear!

Enjoy your stay!
Click to expand...
Thanks,
 
thestelster

thestelster

Ultra Member
Premium Member
@Stainless201 Hi Ron check this post:

canadianhobbymetalworkers.com

Excello 602 Power Feed Repair

I decided that I wanted to fix the power feed on my Excello 602. The 602 have a power feed mounted on the knee which is basically a DC servo motor and a speed controller. The servo is constantly turning and when the lever on the saddle is engaged, a spline shaft is engaged that connect to the...
canadianhobbymetalworkers.com canadianhobbymetalworkers.com
 
LenVW

LenVW

Process Machinery Designer
Premium Member
Stainless201 said:
Hi Craig, thanks
Click to expand...

Stainless201 said:
I. am in Hamilton Ontario
Click to expand...
Stainless201 said:
I. am in Hamilton Ontario
Click to expand...
Hey Ron,
Welcome to this group.
I apprenticed at . . . Ex-Cell-O Special Tools Division
You can try Roy (below) he has a shop called ‘Preston Rebuilt Machinery’ in Cambridge.
He used to repair a lot of the 602s in the area, but, recently has focused more on FIRST mills.
He may still have some inventory of XLO parts.

Roy Weidinger - Preston Rebuilt Machinery
385 Dundas Street, Unit 6D
Cambridge, Ontario
(519) 621-4258
 
You must log in or register to reply here.
Top