.
Are we talking about bronze, the part in the lathe while it's spinning, or the bike seat here.......
Brass vs Bronze for heat sink backing?
- Thread starter Xyphota
- Start date
Are we talking about bronze, the part in the lathe while it's spinning, or the bike seat here.......
140mower
Don
Yep. That's about it.
Standard rules as apply to most shop work. Wash your hands, keep your fingers out of various orifices, don't smoke.
I dealt with a LOT of Beryllium Copper alloys, and had to deal with new supervisor, after new supervisor, that lost their minds over "Beryllium" without ever reading the actual MSDS sheet on the stuff.
The 'rules' for Be-Cu alloys were essentially, No smoke, No sparks, No food nearby. So, cleanliness, to avoing ingestion, and no welding or grinding, or similar hotwork. Pretty easy terms...
Your biggest hazard is dropping it on your foot!
Dan Dubeau
Ultra Member
All of the above. There are very few situations where licking it is the best way forward.
I wanna watch you convince my dog of that.
Dan Dubeau
Ultra Member
No mucus membrane exchanges. Don't inhale fumes, don't eat with dirty contaminated hands, wear PPE. Should be standard practice, but I know what chemcool tastes like, so.....
It's a shame about the big stigma behind BeCu. Ping used to make some great golf clubs from it. I've always wanted a nice set of Eye 2 BeCu irons. Old tech now, but very nostalgic.
Dan Dubeau
Ultra Member
When your only tool is a hammer.....
Proxule
Ultra Member
Former Member
Guest
Too further influence you choice of material, google cooper welding spoon. I bought one years ago (i dud the research why they are still desired) when I found out about them and they where on sale at HF.
The long and short is that if all materials cooper sticks the least, has a high melting temp and is an excellent heat transfer medium.
While it has some challenges on machining a little caution and effort does two things. Gets a good finish and more importantly improves your skill as a machinist.
So......
The long and short is that if all materials cooper sticks the least, has a high melting temp and is an excellent heat transfer medium.
While it has some challenges on machining a little caution and effort does two things. Gets a good finish and more importantly improves your skill as a machinist.
So......