Morgan's Pub on 17th

[Kris Jensen]

Just finished the install today here's how it went

 

[Kris Jensen]

 

[Kris Jensen]

 

[Kris Jensen]

 

[EricB]

Awesome work, Kris!! This is very cool, I bet the customer is thrilled. Did you cut the steel with that protective plastic on? If so how bad were the fumes?

Sent from my B15 using Tapatalk

 

[Tom O]

Great job!!

 

[Kris Jensen]

Awesome work, Kris!! This is very cool, I bet the customer is thrilled. Did you cut the steel with that protective plastic on? If so how bad were the fumes?

Sent from my B15 using Tapatalk

Actually there were no fumes, the film is designed for laser cutting which gets a lot hotter then plasma plus on the water table I was able to close the garage door and cut with little to none build up of fumes

 

[Jwest7788]

Look Fantastic Kris!

JW

 

[Kris Jensen]

Thanks

 

[Janger]

Is that stainless or cold roll? What about rust?

 

[Jwest7788]

I'm guessing it got a few clear coats on it?

 

[Kris Jensen]

Is that stainless or cold roll? What about rust?

The cutouts are stainless and the frame is steel with clear coat

 

[Janger]

Clear coat... What exactly?

 

[Kris Jensen]

Clear coat... What exactly?

I clear coated everything except the stainless and the acrylic spacer that separates the the rusted panel and the stainless so the stainless doesn't touch the rust

 

[Jwest7788]

Clear coat... What exactly?

Like a clear coat from a rattle-can I suspect.