• Scam Alert. Members are reminded to NOT send money to buy anything. Don't buy things remote and have it shipped - go get it yourself, pay in person, and take your equipment with you. Scammers have burned people on this forum. Urgency, secrecy, excuses, selling for friend, newish members, FUD, are RED FLAGS. A video conference call is not adequate assurance. Face to face interactions are required. Please report suspicions to the forum admins. Stay Safe - anyone can get scammed.

Active project - 1972 MGB

Yes that one looks a bit on the tired side. Just a note, you can get a thing called a speedy sleeve, that is pushed on over a worn hub/shaft to give a new wear surface, they usually come with a seal, least way the ones I have used have. So far a couple of Cummins pickup engines, various tractor engines. Don’t know if available for everything, LOL.
Note, a outer ring can move on a harmonic damper when aged and miss up engine timing, causing some hair pulling.
 
Yes that one looks a bit on the tired side. Just a note, you can get a thing called a speedy sleeve, that is pushed on over a worn hub/shaft to give a new wear surface, they usually come with a seal, least way the ones I have used have. So far a couple of Cummins pickup engines, various tractor engines. Don’t know if available for everything, LOL.
Note, a outer ring can move on a harmonic damper when aged and miss up engine timing, causing some hair pulling.
I know speedy sleeves are available for the flywheel end of the crankshaft where it goes through the main seal. No idea if on is available for the crankshaft pulley.
 
I hope you have help with pulling some things out it makes it so much easier.
Nope, total solo effort. Made slightly harder because I didn't remove the correct transmission mounts. There are five different mounts...I went for the easily accessible one and the bloody transmission crossmember didn't drop to the ground when I was lifting the engine out.

Couldn't get under the car because the hoist was in the front, the Quickjacks prevent side entry and the car was backed up as far as it could go so I had room in front of the car for the hoist. With the engine suspended in the air I then had to use my extra long arms to reach way the hell down into the transmission tunnel and unbolt the mounts I could reach and pry the crossmember off with a pry bar.
Still I had the engine out in 90 minutes. 🙂
 
Unfortunately with the Quickjacks both sides operate simultaneously so I would have to block both sides.
 
Back
Top