kevin.decelles's latest activity

Confirming that 6x26 is too small?

@kevin.decelles Hi kevin, I'm down by Estevan. The machine and metal desert. Good luck finding anything down here. Unless, of course...

Draft angle is a taper you apply to your pattern to allow you to pull it out of the sand without destroying your imprint

Where about in SE Sk? I may have some precasted blocks that would work

I received a request from a former co-worker for a custom made cleaver. The blade isn't as thick as some heavy cleavers that weigh up to...

Welcome from eastern Saskatchewan.

i did aliexpress (vevor probably). 13 piece cutter set + drill delivered for ~500 two years ago. STill going strong. Use it a lot.

It’s funny to watch my dad when he gets a call from one of these guys….. no computer, no internet, Flip phone, Pays in cash or...

I used to hate it when I was watching an auction and at the last moment someone here would post it and 100 of my friends (competitors)...

I don’t think I’ll ever go back . So much control, web UI, cameras , wifi…..

I put Klipper on my Ender 3V2 and I can confirm the speed improvements. Over 45% faster overall. 13 hour prints happen in 6-7 hours...

Welcome from 70km east of Yorkton. We have water and fire, thx for asking!

Today we began the 'parking' of the press close to the storage shelves, piick up front ne, drag over, down, back end up, side, down...

I've been ruminating on fitting the TX650.with a hydraulic clutch actuator for some time. Originally a plastic screw type actuator was...

My gut thought is walk away from this and get a new machine 14 years old, something blew the fuse the first time and something smoked in...