Recent content by D. Gray Drafting & Design

  1. D. Gray Drafting & Design

    Hello from Winnipeg

    Welcome from West K Winnipeg
  2. D. Gray Drafting & Design

    Machine What is the swing of your lathe?

    Simple question, What is the swing of your lathe? Please answer in terms of diameter and in Inches (mm/25.4=inches) If you have more than one lathe you can answer up to three times. If you have more than three lathes, you suck, answer for the three you use most often. Enquiring minds want to know!
  3. D. Gray Drafting & Design

    D. Gray D&D - HEAVY DUTY KNURLING TOOL KIT

    That's great news Craig. I was just about to PM you about some replacement plates. Now everything you see will need a knurl. :)
  4. D. Gray Drafting & Design

    D. Gray D&D - HEAVY DUTY KNURLING TOOL KIT

    looking good Craig!
  5. D. Gray Drafting & Design

    D. Gray D&D - HEAVY DUTY KNURLING TOOL KIT

    I found the end of the threads leaves a bur. Chuck as Gerrit says and perhaps a pass with a fine file.
  6. D. Gray Drafting & Design

    D. Gray D&D - HEAVY DUTY KNURLING TOOL KIT

    Thick superglue works well. Make sure the plates are well deburred and sit tight together. I sharp rap with a drift will separate the parts, (heat can cause nasty fumes). Regards D.G.
See more
Top