• Spring 2024 meetup in Calgary - date Saturday, April 20/2024. discussion Please RSVP Here to confirm and get your invitation and the location details. RSVP NOW so organizers can plan to get sufficient food etc. It's Tomorrow Saturday! you can still RSVP until I stop checking my phone tomorrow More info and agenda
  • We are having email/registration problems again. Diagnosis is underway. New users sorry if you are having trouble getting registered. We are exploring different options to get registered. Contact the forum via another member or on facebook if you're stuck. Update -> we think it is fixed. Let us know if not.
  • Spring meet up in Ontario, April 6/2024. NEW LOCATION See Post #31 Discussion AND THE NEW LOCATION

Very busy week-end

Debovsky

Debovsky

Active Member
After committing on a bench lathe and milling machine two weeks ago, this week-end was a good opportunity to fit them out with the usual goodies. Installed a QCTP, 2 axis DRO, and work light on the lathe and installed the bracket for the 3 axis DRO for the mill. The linear scale of the ToAuto are stuck somewhere between Hong-Kong and Canada... But it should get here this week. 20211011_155204.jpg
 
CalgaryPT

CalgaryPT

Ultra Member
Vendor
Premium Member
BTW — that's a great bench design. I really like the partial cantilever. It should give you more knee room when sitting as well. Nicely thought out.
 
Debovsky

Debovsky

Active Member
Thanks for the nice comments. Encouraging. Right now I'm almost done installing the 3 axis DRO on the mill. I will post few picks when I'm done. Maybe this week-end.

BTW, this little DL50 DRO is really nice to operate. Very nice addition to the lathe.
 
You must log in or register to reply here.
Top