Reeve drives is what is on a variable speed milling machine.
I've worked on lots early in my career. They can be finicky, but generally very simple. On Bridgeport style mills (and this drill should be along the same basis) there are 2 variable pulleys, one spring loaded, the other by chain which will open and close the pulleys alternatively. The upper pulley half on each pulley should have nylon bushings and steel keys that slide up and down. Those were generally the biggest issue, but are cheap and easy to make. Servicing them can be a pain if you ever had to do bearings or a belt change. (Again, bearings are reasonbly cheap) The hardest part is the belt, you have to ensure the chain side pulley is wide open before tearing it apart to allow easy removal and install of the belt, otherwise you are fighting the spring pulley as it will always naturally close tight, meaning if you have both pulleys closed tight, the belt will never come off or go on. Now again, a bridgeport has Hi/Lo and a few other gadgets in there, this drill should be significantly simpler and lighter duty aka cheaper parts.
I wouldn't hesitate buying one that had a reeve drive.