Machine Rockwell Beaver 25-700 parts wanted!

[grease monkey]

Hey all, my little Rockwell is due for a going through, and I find that the back gear itself has a tooth missing on both the large and small intermediate gears, so I'm hoping someone on here has one sitting for parts?? the feed transmission also has issues, but I think its just a woodruff key clipped off... here's to hoping!

Also, the 1-2-3-4 indicator wheel on the cross slide also has a tooth missing and doesn't run smoothly, so this as well I would like to replace if I could!

On another note, I'm on the hunt for a keyless chuck on a #2 MT taper also for this lathe, and a MT#3 taper for my Busy Bee 1237G lathe, I do have a MT#6 taper (I think) adapter to a Jacobs #6 taper, if anybody has a need for one??

 

[Susquatch]

Hey all, my little Rockwell is due for a going through, and I find that the back gear itself has a tooth missing on both the large and small intermediate gears, so I'm hoping someone on here has one sitting for parts?? the feed transmission also has issues, but I think its just a woodruff key clipped off... here's to hoping!

You have a really nice mill. Just buy the required gear cutter set on Ali Express and make your own gears. It's not that hard to do.

Also, the 1-2-3-4 indicator wheel on the cross slide also has a tooth missing and doesn't run smoothly, so this as well I would like to replace if I could!

What is that indicator? Are you perhaps referring to the thread dial? Again, easy to make your own gear for it.

On another note, I'm on the hunt for a keyless chuck on a #2 MT taper also for this lathe, and a MT#3 taper for my Busy Bee 1237G lathe, I do have a MT#6 taper (I think) adapter to a Jacobs #6 taper, if anybody has a need for one??

Most keyless chucks are on replaceable arbours. Easy to find a chuck and then buy an Arbour on Ali or Amazon or Accusize (with the CHMW discount).

 

[grease monkey]

that idler gear would be a trick to do, my skills are not up for that, its a single unit with a large gear on 1 end and a bigger one on the other.
and yes, that is the thread dial, I was just reaching out to fish for parts, if that fails, then option 2 may become option 1!

how does that accusize discount work?

 

[Susquatch]

that idler gear would be a trick to do, my skills are not up for that, its a single unit with a large gear on 1 end and a bigger one on the other.

I have great confidence in your ability to do it.

how does that accusize discount work?

There is a post that explains it on the members only forum. Should be easy to find. I'd post a link but that might make it possible for a non-member to see it.