• Scam Alert. Members are reminded to NOT send money to buy anything. Don't buy things remote and have it shipped - go get it yourself, pay in person, and take your equipment with you. Scammers have burned people on this forum. Urgency, secrecy, excuses, selling for friend, newish members, FUD, are RED FLAGS. A video conference call is not adequate assurance. Face to face interactions are required. Please report suspicions to the forum admins. Stay Safe - anyone can get scammed.

QCTP Tool holder

YYCHobbyMachinist said:
I've never seen a center set up in a tail stock chuck like that before. That's different?
Click to expand...

YYC

I was perusing a Tubalcain video today and noted he points to the same center you asked about. I just used it in the lathe chuck vs the drill press chuck, where it was about 5 minutes earlier. Handy little center. Check out at the 4:00 minute mark here.
Cheers,

 
You must log in or register to reply here.
Back
Top