ted525
New Member
I posted about my kitchen utensil project some months ago, and got some very helpful feedback here.
I then found someone who helped revise my 3D model to make it into two parts, instead of one.
This version should be easier to fabricate in steel by spinning or cnc.
I'm looking for a Canadian collaborator who could make this for me, for a reasonable fee.
I'll share the link to the model in a reply below. The link will be taken down after a couple days; after that I'm happy to share it privately by request.
Thank you
I then found someone who helped revise my 3D model to make it into two parts, instead of one.
This version should be easier to fabricate in steel by spinning or cnc.
I'm looking for a Canadian collaborator who could make this for me, for a reasonable fee.
I'll share the link to the model in a reply below. The link will be taken down after a couple days; after that I'm happy to share it privately by request.
Thank you