skippyelwell
Ultra Member
I have the Multifix QCTP set up on the lathe now and started looking for a tool holder to handle all my 3/4" shaft boring bars.
All the Asian Multifix products I looked at seemed to want to sell me a whole kit and I couldn't get a human to respond to my questions about selling one holder.
Then I found these guys in Germany, https://pewetools.de/en/product-category/tool-holders/
He has hundreds of tool holders to handle any tool you can use on a lathe, there are 112 different tool holders alone just for type A tool post.
I ordered last week and it arrived yesterday, the shipping cost more than the product.
It is very well made and it not only holds the 3/4" shaft boring bars but also the 1/2" as well which is a nice bonus.
He carries a sweet holder made for a ER16 collet holder.
All the Asian Multifix products I looked at seemed to want to sell me a whole kit and I couldn't get a human to respond to my questions about selling one holder.
Then I found these guys in Germany, https://pewetools.de/en/product-category/tool-holders/
He has hundreds of tool holders to handle any tool you can use on a lathe, there are 112 different tool holders alone just for type A tool post.
I ordered last week and it arrived yesterday, the shipping cost more than the product.
It is very well made and it not only holds the 3/4" shaft boring bars but also the 1/2" as well which is a nice bonus.
He carries a sweet holder made for a ER16 collet holder.
