R
Raymond
Guest
HI there
I was referred by Joshua message in this forum.
Im looking for a thread adapter that has female m8x1.25 to a male m10x1.25. Female end would need to be at least 3cm deep and male end to be 2cm long. I'll let you know thickness(diameter) of the material when I measure it but something like 1.5 cm should be enough. I would like the material to be study metal but aluminum is just as good.
I can tap and die myself but can't cut the material down to size.
Please let me know the cost of labour and material. You can email me at bluelobster123@hotmail.com.
Thank you everyone. Special thanks to Joshua for the referral.
I was referred by Joshua message in this forum.
Im looking for a thread adapter that has female m8x1.25 to a male m10x1.25. Female end would need to be at least 3cm deep and male end to be 2cm long. I'll let you know thickness(diameter) of the material when I measure it but something like 1.5 cm should be enough. I would like the material to be study metal but aluminum is just as good.
I can tap and die myself but can't cut the material down to size.
Please let me know the cost of labour and material. You can email me at bluelobster123@hotmail.com.
Thank you everyone. Special thanks to Joshua for the referral.
