• Scam Alert. Members are reminded to NOT send money to buy anything. Don't buy things remote and have it shipped - go get it yourself, pay in person, and take your equipment with you. Scammers have burned people on this forum. Urgency, secrecy, excuses, selling for friend, newish members, FUD, are RED FLAGS. A video conference call is not adequate assurance. Face to face interactions are required. Please report suspicions to the forum admins. Stay Safe - anyone can get scammed.

DIY Chip Guards, and Catchers

TAF-fy Boy

Super User
Not sure if this is the place to post this thread, but I have a few questions for everybody about methods of keeping chips from tools getting on the other side of the room,

I feel like a lot of my time is spent cleaning the floors, bench, etc, after any small task.

Obviously I do throw a piece of plywood, cardboard, aluminum sheet up when I have the space, but I always see larger cnc setups encased - and some folks with different types of plexiglass and the like fixed to a vise.

Do any of you take the time to actually make and use such things or is it better to just accept some mess and cleaning instead of trying to control flying coils of metal? Just looking for opinions.
 
I've been meaning to do that my my CNC converted mill but have never gotten to it.
Personally I'll probably make some 3D printed fittings that fit in the T slots. Design them so that they hold a piece of thin plexiglass which can be easily removed. I'll avoid using magnets for obvious reasons.
 
I think the mill is easier than the lathe, cnc or not. Mill you can throw a cardboard box up to contain the flinging mess, the lathe seems harder to contain. I have the full enclosure on my cnc mill and its great but the manual lathe tosses oil, chips and strings everywhere, including hot burning chips on my hands as I advance the carriage.
 
I too have not yet figured out how to enclose the mill to hold in chips. Same with the lathe. Since the mill housing has to cover the extreme ends of motion it takes up a lot of space. That's what is holding me back.
 
I made a quick stand from a couple of old '90s pole lamps with a 3d printed bracket to hold a cross-bar, and from that I hang those flame retardent (fibreglass?) blankets from princess auto, basically a welding screen that is easily portable. I put that next to my milling machines to 'contain' the bulk of the material. 90% bounces to the floor and is swept up.

My garage door rails also extend into the shop 8-9 feet and I can hang the same blankets using curtain hooks too. I use this for welding a lot. Quick and easily to move around.

For my t-slots i use lexan/plexiglass sheets with bolts through it to position them. I also have 3d printed individual slot covers in lengths of 2-6" in. to minimize chips in the slots.
 
Don't complain gentleman, my shop doesn't get messed up ( more messed up) because the honey do list is too big and doesn't include any shop time requirements.
 
I have a cure for that...its call "slovenliest "
Don't worry, I try that whenever possible . . . problem is my cat makes enough mess for all 3 of us as it is.

Don't complain gentleman, my shop doesn't get messed up ( more messed up) because the honey do list is too big and doesn't include any shop time requirements.
HAH, my shop is just part of the apartment so its all the same around here!
 
Back
Top