• Spring 2024 meetup in Calgary - date Saturday, April 20/2024. discussion Please RSVP Here to confirm and get your invitation and the location details. RSVP NOW so organizers can plan to get sufficient food etc. It's Tomorrow Saturday! you can still RSVP until I stop checking my phone tomorrow More info and agenda
  • We are having email/registration problems again. Diagnosis is underway. New users sorry if you are having trouble getting registered. We are exploring different options to get registered. Contact the forum via another member or on facebook if you're stuck. Update -> we think it is fixed. Let us know if not.
  • Spring meet up in Ontario, April 6/2024. NEW LOCATION See Post #31 Discussion AND THE NEW LOCATION

Calgary Member

Q

Quinn

New Member
Hey!

Relatively recent addition to the forum. It’s been a few months of reading and learning.

Located in Calgary. Purchased a old, and albeit quite worn out lathe from an contact. Have to cut your teeth somehow.

Mainly making lower precision custom bike parts, but over time will be improving performance of my old 1954 Logan 200 lathe to be a decent machine.

Always on the lookout for a reasonable sized mill. I would appreciate any leads. Ideally stepping away from a post / drill mill but money talks and all options considered!

Quinn
 
P

Perry

Ultra Member
ha ha I'm a little slow this evening.

Pretty nice day out there today......I know this isn't going to last.
 
Q

Quinn

New Member
Motorized! It’s a parts bike comprised of 50’s, 60’S, 70’s and custom Harley Davidson

Currently it’s spacers, control knobs on the carb, bolts, etc. I have a list of items to do but also want to do a rear axle to tighten up the 50’s wheel a bit, etc. I’ll be needing some mild mill help for that just to make some flats.
 
You must log in or register to reply here.
Top