Bernerd D1-4 Collet Chuck

[jgimp69]

I'm throwing this back out here. I tried selling it last year but the deal fell though and got tired of tire kickers, so I took it down...

Burnerd collet chuck with a D1-4 camlock mount. Collets to 1-1/2”. Some normal wear but in good condition. I did a runout check in my lathe on the taper and the indicator didn’t even move. I have a vid but it wouldn’t let me load it.
Looking for $450 but very willing to trade for something I would use more often. Looking for sine plate, vee blocks, angle plates, larger dial/digital calipers (12-24”), 3-6” outside mic’s, 5C spin indexer machinist made setup blocks/larger parallels etc or make an offer.
I really don’t want to sell it but would rather repurpose it’s use to enable me to get something I would use more often.

Located in the Goderich Ont area but do travel in the Southern Ontario area frequently so may be able to meet up or deliver depending on location

 

[Lucky7]

IMO, the collets alone are worth what you are asking. You may want to state if that is a KC-15 set, or something else. Closers for different spindle types come up frequently. Probably just the angle of pic, but I cannot tell if you have the nose piece to draw in the collet?

 

[jgimp69]

IMO, the collets alone are worth what you are asking. You may want to state if that is a KC-15 set, or something else. Closers for different spindle types come up frequently. Probably just the angle of pic, but I cannot tell if you have the nose piece to draw in the collet?

It does have the closing nut and wrench. Just the angle of the pic. Not entirely sure of the model #. I can break out the magnifier and see what I can read on it.
The price is right for sure, just figure someone from here can give it a better home.