I have a 6" 3 jaw chuck, D1-4 cam lock mount that came with my generic 12 x 36 gear head lathe I bought used about 8 years ago. The chuck only came with one set of jaws, no outside jaws.
I also have an independent 4 jaw chuck that I often use but I wish I could get a set of jaws for clamping larger items in the 3 jaw.
I don't have any information on the manufacturer of my 3 jaw, I think its a Taiwanese lathe, plate is stamped 2001 12.
Anyone know if I can purchase a set of outside jaws for this chuck or do I need to look at a new 3 jaw chuck with two sets of jaws?
Any recommendations on a Canadian supplier for a 3 jaw chuck for this lathe, preferably 6" or larger?





I also have an independent 4 jaw chuck that I often use but I wish I could get a set of jaws for clamping larger items in the 3 jaw.
I don't have any information on the manufacturer of my 3 jaw, I think its a Taiwanese lathe, plate is stamped 2001 12.
Anyone know if I can purchase a set of outside jaws for this chuck or do I need to look at a new 3 jaw chuck with two sets of jaws?
Any recommendations on a Canadian supplier for a 3 jaw chuck for this lathe, preferably 6" or larger?




