Search results

RSVP please

I am planning on attending William

if it turns out to be nmtb40 and you wish to sell let me know William

my thought on making these are as follows 45 deg dovetail cutter 45 deg champher mill and an end mill smaller than the slot width, moving it side to side to get the slot dimension this has worked well for me when a pre made blank rail is delayed that said a blank is the way to go

while in the process of a machine tear down and repair, i remembered an story about using neddle valves to control the oiling on a mill. and in this case i could see that 2 of the lines had become plugged with debris and with no control on the individual output of each line the oil flows to the...

for those that were interested in the final cost of the mill winning bid 2300 auction fees 414 GST 135.70 picker truck hire for transport 2hrs 272 fuel premium80

Just so you know the radiant heater is very nice but one thing to note with a 10 foot ceiling you may find it a little warm on the head if you mount it near a standing work area if it helps you can see what i mean if you you happen to live nearby (langdon)

I would suggest you place your water separators as far from the compressor as possible as this would aid in the cooling of the air and allow for better water separation so if you are running lines in you shop place the separators at the tool connection points I would suggest you only dry the...

thank you

I would suggest that any coated drill bit will only work until you have to sharpen and then good luck For long term use (sharpening as required) a full length material such as cobalt may be a good choice