Search results

I think I should also spend some time learning video editing!

. I spend about 6-10 hours a day in my machine shop, and those hours are busy, which is far more diligent than when I'm at work. Even so, a lot of work was delayed, for example, my CNC transformation process had to be temporarily stopped. Perhaps this is a problem that non-professional...

Find a piece of round steel, 182mm in diameter, and start making a flange base. Lathe machining cylindrical, flat. Then use 3-axis CNC punching, this time learning G102, equal round punching. Follow the instructions to program, and then test on air. After confirming that there is no problem...

Find an old abandoned chuck and retrofit the back-end mount into a front-end mount

I would like to say two important points in my actual operation: 1. Deflection Angle, I initially made 1.05 degrees, in the actual operation, the small pallet was 0.5 degrees off, so the actual deflection Angle I used was 1.65 degrees. 2. Bearing selection should focus on axial strength, so I...

前几天，因为需要制作一些六角工具，所以买了一个很差的冲柄，只用了一次，就坏了。 后来即使用MT4锥柄改造冲床手柄也损坏过一次，我总结了大概的故障原因，然后开始制作偏心冲床。 最远端使用小滚珠轴承（内/外径9/26），然后是圆锥滚子轴承20/42，然后是滚珠滚珠轴承20/42。 然后，我制作了另一个类似结构的更大手柄，使用更大的手柄，并且还优化了轴承的组合。轴承内外径：9/26；25/52；25/52.. 试验结果：由于轴承组合结构不合理，小工具手柄很快损坏。 为了节省材料，我用了两段不同直径的钢材，用车床加工成紧密配合的尺寸。 使用液压机将其压在一起 采用 TIG...

Yes, but I was very disappointed in the ending. I tried to make a rotary broach tool myself.

If it doesn't take too much time, please translate it into English. I would also like to know the effect of the translation software you use. I think it is about the reason of being particularly busy recently :1. The quality of the rotary stamping handle purchased is very poor, and only one...

I am very sorry that I forgot to switch back to English after English was translated into Chinese, and by the time I found it, I could not edit it. I will pay attention to this problem and avoid it from happening again in the future.

今天买了一个内冲工具，做了一个17mm的套筒来测试。 I bought an internal punch tool today and made a 17mm sleeve for testing. 打一个孔并压一个 15mm 的轴。 Drill a hole and press a 15mm shaft 然后将其焊接在一起。 Then weld it together 高温弯曲。 High temperature bending. 高温淬火。 High temperature quenching 成功地减少了巨大的间隙摆动。 Successfully...