Search results

South of Calgary. From the Aloris catalogue page 3 for sizing a T-nut the chart goes like this: Make of lathe - Craftsman 12" model 101 - 28900 Swing - 12" Slot on my compound for the T-nut: A - 30 mm/1 3/16" B - 26.05 mm/1.027" C - 15.85 mm/0.624"/5/8" D - 8.35mm/0.328"/21/64" E - 7.90mm/0.310"...

No I don’t have a mill. I will take the current suggestions & make a temporary one out of flat stock & then use one of the Aloris tool holders to modify a more permanent one. Any suggestions on what kind of end mill bit to use & where to purchase one, speeds to use at etc. Thanks again - you...

I've also discovered the thread pattern to hold the Aloris tool post to the compound of my lathe is 9/16-18.

Great tip, thanks very much for that.

Does anyone have a T-nut for an Aloris AxA Quick Change Tool Post that'll fit a Craftsman 12' Metal Turning Lathe model 101 - 28900?

Very helpful, Thank you. Did you need to change out the motor eventually?

Thank you the tips, very worthwhile. My 12.5 Dewalt has been a steadfast performer in my shop for years. This summer I did a major overhaul as the rollers were skipping While pulling stock in. Installed all new bearings, new belt, a new belt plus allen head bolt so taking out bearings in the...

My neighbour is looking for a portable planer in the 12" - 13" size. I told him I'd check with the group. Thanks.

My neighbour is looking for a portable planer in the 12" - 13" size. I told him I'd check with the group. Thanks.

Copy that.