Search results

Sorry to hear about your catalytic converter. Someone tried to remove mine in the parking lot of a Home Depot. They cut the rear pipe half way through before abandoning the exercise for reasons unknown. I was lucky just had to weld the cut closed.

It took me a while to learn the difference between rust and old coolant with grime and a light patina of rust. LOL

I have the same scales and the same concerns. The concern I have with mounting them with the face down is it exposes them to accidental bending when putting heavier items on the table. That is why I went with the aluminum angle and supported it on the ends and in the middle so it will take the...

After reading your Hartford Clone post I went back and had another look at mine. Initially I was going rotate the X axis scale 90 degrees but realized that would make it difficult to check it and it required another bracket in the middle due to the length of the scale. I decided to install a...

You got me thinking about my install on the x axis and I realized that there has to be a better way. I came across this this: I wish I had seen this sooner. Will go out to the shop and do this to mine this afternoon. At least I can use the existing holes and will just have to make the brackets...

Here are more pictures of my install. Hopefully these will help with the bracket arrangement. If you have any questions let me know. Quill X Axis Z Axis Y Axis

I will do that today.

Great, would be good to see you again.

I bought it off Amazon. https://www.amazon.ca/dp/B08C6WD17Z/ref=pe_3004600_462762960_fb_remail%5Fprodpg but I got them to price match from AliExpress as there is quite a price difference. AliExpress...

I finally got around to installing the DRO on my mill. The read out is mounted to the ceiling as the start panel was in the way and I didn't want to relocate it. It is a Ditron unit and the scales are magnetic. The installation was a bit of a challenge on the Y and Z axis. The left side of the...