Recent content by Farmboy1

Modern 14”x40” lathe Modern 22”x80” Lathe Modern drill grinder 1/4”-3” capacity Modern 10”x 50” milling machine 50 ton press Jet geared drill press 7”x12” metal band saw Bend Pak 10 000lb 2 post vehicle lift Danmar 7000lb 4 post vehicle lift 3 ton overhead crane 77’x 80’ shop

No, I had a bunch of ridgid sheets of insulation and ripped them to width in the table saw then put them in place and put in low expanding foam to seal up any gaps between the studs and the panels. Under the slab is 2” thick of the same panels with rebar on top of that and we went 10” thick slab...

Yes plus 2x10 walls filled with ridgid structural foam insulation and completely sealed.

Radiant heat for the main area 2x Calcana 100 000 btu

Yes the small one is a 14x40 and the big one is a 22x80, the mill is a 3VM with a 10x50 table and variable speed, I also have a 50ton press, metal band saw and modern drill grinder that will grind from 1/4”-3” bits

Very nice lift, it does anything I need to lift so far, extended lift version as well, I had the room with 20’ ceilings.

We are in the Hand Hills South West of Hanna.

Yes, we are still in the process of moving in, large lathe still needs levelling and power hook up. So far very happy, thank you for the kind words.

A little late to the discussion, new to this, just built a new 76x80 shop am a machinist/heavy duty mechanic by trade so it is set up very well. I will attach some pictures below.

Go ahead and give me a call if you are interested and I would be happy to go over the details with you.

12”

I have a brand new never used D1-6 chuck for sale, does not fit either of my lathes. Call from 9-5 at 403-854-1415