Spring cleaning surplus tooling and inserts

[Kelly McLaughlin]

Hi Folks! cleaning and making room : )
Face mill is 50mm (I think forgot to measure it) 40.00 with inserts. used 1 time my little mill can't drive it at least not in any useful fashion.
CNMG inserts 25.00 for a box of 10 I sold the boring bar with my lathe when i closed the shop and I guess I forgot : )
Right and Left tool holder with inserts suitable for 10 inch and under lathe or small work 16mm / 5/8 shank 40.00 for the tool holders 2.00 ea for inserts boxes only 1 has 8 the other two are full (10)
I can mail if you like the face mill and inserts will go in a flat rate box for 17.95 the other stuff should go in a padded envelope. prices are firm if I'm doing the running around and packing.

 

[KeeponDragon]

Hello there Kelly,
is the face mill an R8 arbor?

 

[mickeyf]

Looks like an R8, but what is the diameter of the pilot arbor5?

 

[Kelly McLaughlin]

yes it's an R8 I think the pilot is 7/16 20 but I'd have to check that

 

[David]

yes it's an R8 I think the pilot is 7/16 20 but I'd have to check that

I've not seem R8 tooling that wasn't 7/16-20

 

[KeeponDragon]

I've not seem R8 tooling that wasn't 7/16-20

snoop around on ali-x....you'll find metreeck R8
I almost bought one lol

 

[KeeponDragon]

yes it's an R8 I think the pilot is 7/16 20 but I'd have to check that

I'll pop a DM in your messages Kelly

 

[Dan Dubeau]

One of the guys I worked with bought an r8 facemill adaptor on amazon, and apparently it was pretty amusing watching him hold it up trying to spin the drawbar into the m12 hole for a while before he realized it was metric.... I didn't get to watch it, just heard the guys retelling the story at breaktime lol.

 

[David]

Guess I’ve had the luxury of only dealing with domestic R8 tooling

 

[Kelly McLaughlin]

Face mill is gone!

 

[Susquatch]

I've not seem R8 tooling that wasn't 7/16-20

I hadn't either till I got some by mistake a year ago or so. Now I always check before I order.

I think the wierdo was m12.

 

[David]

I hadn't either till I got some by mistake a year ago or so. Now I always check before I order.

I think the wierdo was m12.

When I had MT3 tooling all I saw was M12 drawbar threads.

 

[Susquatch]

When I had MT3 tooling all I saw was M12 drawbar threads.

Yet, all of my mill/drill MT3 tooling is 3/8-16.

 

[mickeyf]

When I had MT3 tooling all I saw was M12 drawbar threads.

Yup. Had that on my RF-whatever it was round column mill.

I may have mis-named the part. By "pilot" I meant the the stubby shaft that aligns the face mill itself on the R8 arbor, and that the cap screw threads in to.

 

[Tom Kitta]

All of my MT3 mill tooling is metric.

 

[140mower]

Yet, all of my mill/drill MT3 tooling is 3/8-16.

As are mine...