I'll get a photo shortly, these are the adapters that go into the spindle nose to hold 5C collets with a draw bar. More accurate and solid than a collet chuck. Several lathes use this 4.5 spindle nose as its just big enough to fit a 5C collet (I'm guessing the 4.5 was created for that purpose)
No make indicated but its old school quality, hardened and ground. Came out the Bulova plant in the US and they didn't buy junk.
These seem to go for $175 US on ebay and there is someone selling new ones for just under 200 US...... that look like they've been finished with emery paper!
I'm thinking $175 CDN + shipping.
Let me know via PM if interested
thanks
Mike
No make indicated but its old school quality, hardened and ground. Came out the Bulova plant in the US and they didn't buy junk.
These seem to go for $175 US on ebay and there is someone selling new ones for just under 200 US...... that look like they've been finished with emery paper!
I'm thinking $175 CDN + shipping.
Let me know via PM if interested
thanks
Mike