Milling Machine in Sicamous BC - $2000

[KeeponDragon]

Listed yesterday

> FB Link <

 

[Jswain]

Great price

 

[historicalarms]

One thing I just noticed on these machines is that a belt speed change can be done so much easier than the round column machines. With the head tilt & swivel capability the belts can be maneuvered to be right in front of you instead of having to climb onto something to reach the belts on a round column.

 

[SSPhoto]

Been trying to get more info from the seller but curious if anyone here knows the model or specs? Looks similar to the clones from KMS and Busy Bee. Trying to confirm spindle taper and motor horsepower.

 

[Jayham]

Looks like it's wired at 110v so motor is likely less than 1.5hp. Probably 1.0

Also a straight shank tool on the shelf. So maybe r8

 

[KeeponDragon]

I am guessing it's Morse taper. 2nd picture, right hand side, 3 shelf down...next to the open wooden box, there's some kind of chuck or holder, it doesn't look like R8 to my eye...but...we also can't make out the specs on any of the decals either...so who knows until the seller comes back with answers

 

[SSPhoto]

It’s 220v not 110v. Trying to get any answers or arrange a meet with the seller didn’t pan out. Someone else beat me to it. The search continues…

 

[Tomc938]

I am guessing it's Morse taper. 2nd picture, right hand side, 3 shelf down...next to the open wooden box, there's some kind of chuck or holder, it doesn't look like R8 to my eye...but...we also can't make out the specs on any of the decals either...so who knows until the seller comes back with answers

Good eye!

 

[Jswain]

It’s 220v not 110v. Trying to get any answers or arrange a meet with the seller didn’t pan out. Someone else beat me to it. The search continues…

At that price it was probably sold within a few minutes. Or a scam...

2k for that In the west you gotta run to get there and ask questions then.

 

[KeeponDragon]

so true...I had to wait over 18 months to get my Induma for the price I did...
hopefully it wasn't a scam on this machine

 

[FatherWes]

I saw this mill within minutes of seeing this lathe. It sold as I was trying to figure out how I could verify it wasn’t a scam.

The lathe was near Vernon. Sold in less than 2 hours of posting.

Hopefully someone got a deal, and not scammed.

 

[Jswain]

The only way you get scammed is if you send them $$ upfront.

If they are willing to give you an address and you go there with the money, unless they physically rob you = no scam.

If they demand upfront payment because of all the interest and you are gullible enough to send it, then contact me and for $100 etransfer upfront I'll help you get your money back

 

[mickeyf]

This looks identical to my mill, which is R8 and 125V. In a thread I'm not finding, I listed a bunch of identical or nearly identical mills, but a few of them were Sharp VO-A1S, Kao Fong KF-VO-AIS, Husky A1S.

 

[140mower]

I am guessing it's Morse taper. 2nd picture, right hand side, 3 shelf down...next to the open wooden box, there's some kind of chuck or holder, it doesn't look like R8 to my eye...but...we also can't make out the specs on any of the decals either...so who knows until the seller comes back with answers

I was going to say the same........ The wooden box, should be the same cheap set of end mills that I got with my little round column.