Search results

Hey, looking for a sine plate in the 8-12" range, a few various sizes of angle plates and V blocks. I'm located in mid-western ontario/walkerton area but I'm willing to travel (just hopefully not to the guts of Toronto) PM me if you are wanting to clear some space.

So I recently got a Colchester Master running. I found that when the lathe is on (motor and pump running, chuck not engaged), the chuck spins until I hit the brakes a few times. The chuck also continues to spin when I hit the carriage lever to neutral after some cuts. One would assume the...

A couple of buddies bought a sawmill a few years back. It was cutting all sorts of wonky. I went out and found the blade guides all worn and the one guide mounting arm was bent. I threw an indicator on the base and ran the head/blade over and found .100 of change from the front of the teeth...

Was asked to machine up a backing plate for a buddies Clausing lathe so he could mount a 3 jaw on it (It only came with a 4 jaw). Rough machined the plate to about 0.050” over, then cut the tapered bore after tramming the compound slide and finished with the threads. Wasn’t happy with the...

Some more stuff... Baldor L3514TM motor 1.5HP, 1725rpm, 7/8” shaft New bearings installed and tested. Runs good and quiet. $150 Specs in page below https://www.baldor.com/catalog/L3514TM Can send a vid of it running if need be

Doing some more organizing and cleaning up, so thinning out the toolbox drawers. -Assortment of quality HSS, ($25) I do have more if needed -Assorted lathe wrenches, ($25 for all) -Heidenhain edge finder, No idea, make an offer -5 x (1/2-13) LH taps and die, ($25) -Snap on Tappet wrench set...

Seems like a sweet deal https://www.facebook.com/marketplace/item/1784575839029475/?ref=search

Bought these on Amazon for a sweet price and I really should have known better. They were $50 and labeled Fowler and even had Fowler numbers, 52-475-555 The 0.125” slot on the bottom was absolutely terrible. I put them on my mill and ran an indicator along the V and found one side was out...

Looking to get some stuff to get my shop started. I have most of the general measuring tools, collets, cutters etc already but would like to start filling the gap of what I am missing. Probably just easier to list what I’m looking for. -5C indexer and blocks -Angle plates 4-8” range -Sine...

Hardinge 5C collet chuck with a D1-6 camlock mount. Selling this one really sucks as I want to use my 5C collets on my Colchester but it’s a D1-4 camlock. I thought about machining an adapter to use this one. but after some thought, I would rather just invest in a proper Bison D1-4. I’ve...