Search results

How can there be such a small handle size, about 12mm tool rod? I don't think I can make such small knife holders anymore, I mostly make tools for myself and then make some to sell. So, I'll make the 125mm knife holder first. Thank you very much for your drawings. I have saved it on my hard...

Today, I finally finished the production of another 10 knife holders, and I stacked all the knife holders together, and there were 40. Five of them are V-slots with a pitch of 100mm, which is not the model I use, so I will publish them to sell in my Amazon store.

I am very interested in the detailed drawings of your tool holders and tool holders. Is the compatibility of tool holders of different brands the same? You said used is expensive? Example: How much is ----? My tool holder is also a strange size, the V pitch is 99.70mm. I have tried to convert it...

I didn't expect this model to be so huge. This is almost the limit size of this type of tool holder, right? Thank you for the S4 drawings you found for me. If there are S3 and S2 drawings, it will be more perfect. I plan to collect more drawings of tool racks and consider making them...

Thank you so much, Arbutus! I certainly hope that you can make accurate measurements, if it does not take up too much of your time. If you can find the official size data from the website and check the mapping correctly, this is the most accurate data. If I accept your data and make some samples...

I was looking through the DICKSON quick change tool holder the other day, On the https://www.colchester.co.uk/spares/dickson-quick-change-tool-post/ website and didn't find the size of the various models, the appearance of even the most basic size. I emailed and got a reply: trade secret! @...

Look forward to seeing your production process! You must already have the over-mapping drawings, is it convenient to send a copy to me, and we can check the size data with each other! If convenient ------ what is your estimated cost?

Recently, I tried to make some 125 model tool holders, which caused data errors and some minor defects due to abnormal operation of the machine tool. The model of the tool bar is 16mm+8mm, which is also because the wrong gap is cut. (If you don't need it, I can keep it for myself because it's...

The only mounting position I could find was the bright light pole! I think this is a challenge for the installation and fixing of milling machines and lathes, and it is about necessary to make a special fixing fixture.

Now I can finish the processing in about 15 hours, but sometimes the EDM will have some strange faults, resulting in me wasting time and increasing the waste of molybdenum wire, sometimes it may take more than 20 hours. The combination of a beat-up EDM and a completely novice operator is a bad...