Search results

I've tried them all (mostly) over the years but always go back to Walter. Yes they cost more but last significantly longer than PAuto or Amazon stuff, they blend nicer and use better abrasives. Same with zip cuts but I recently bought 2 boxes of Klingspor zip cuts that I'm pleasantly...

I'm also talking the vise itself. I usually lightly stone both the vise bottom and table, wipe clean and lightly oil. I then clamp the vise down and tram the edge so it's square, but also the bottom of the vise jaws to make sure it's not off kilter. Off by a few thou or two and errors can...

End mills can easily walk out of R8 collets especially with heavy cuts. The flutes "pull them out" of the collet, and can actually pull the workpeice up out of the vise as well, as has happened to me plenty of times. There are threaded endmills that lock into specific holders (weldon shank) and...

Haha, It sounds like Yoda was writing the instructions

Princess auto gear motor maybe? DC drive off a potentiometer would be the cats ass

End of February we are usually still knee to waist deep in snow.

Hey, looking for a sine plate in the 8-12" range, a few various sizes of angle plates and V blocks. I'm located in mid-western ontario/walkerton area but I'm willing to travel (just hopefully not to the guts of Toronto) PM me if you are wanting to clear some space.

They have had this stuff on here for what seems like years.

So I recently got a Colchester Master running. I found that when the lathe is on (motor and pump running, chuck not engaged), the chuck spins until I hit the brakes a few times. The chuck also continues to spin when I hit the carriage lever to neutral after some cuts. One would assume the...

A few more