Search results

I flicked it on again tonight just while I was in the shop. It actually sounds worse now :/ Then improved but at different rpms. Maybe the belt(s) need to seat in after the rebuild. Think I'll go to bed too, I'm about ready to hang myself. Planning a visit this week to an older year but same...

Is this from listening to the audio or do you have some kind of analysis software/app that provides insight? What is odd (and should be meaningful) is kind of the low frequency overlay noise that comes in & out. Like something goes out of balance/alignment & then comes in balance again. Like...

I like those knuckle joints, very smart.

The smaller toothed motor drive belt ^left picture^ is was replaced during this rebuild as mentioned, so brand new. And it rides in almost the exact same position as shown. I'm told this is normal.

Cabosil (=Aerosil =fumed silica) will increase viscosity as its intended, but it will also give it a white-ish tone the higher the concentration if you trying to maintain optical transparency. And actually epoxy's themselves can vary in this regard.

Holy labor (and CO2 emission) intensive HaHa. I had a rough idea of the ramen process from watching cooking YouTubes, but didn't appreciate the amount of time. There was a great Sushi/Ramen place close to where I live but unfortunately didn't survive the pandemic. You're making me hungry...

Neat. Is it UV clear epoxy? I did some gift rings but in both cases used the CA glue treatment for the clear finish like what a lot of pen makers use. So every coat application (spinning on a mandrel) give it a spritz of accelerator & that builds up the finish so its essentially instantly...

You beat me to it. I get it now. There is cardboard & then there is cardboard.

Yup still there. Must be 'The Cloud'

Good question. I'll paste the link again to check. https://accusizetools.com/products/electronic-digital-dro-scale-unit-horizontal?variant=35246813020314 this is on the product page, looks a bit more masculine