Search results

I contacted Vevor for the instruction manual, worth a look before laying money down.

That's XLO https://www.facebook.com/marketplace/item/424221103970907/?ref=search&referral_code=null&referral_story_type=post&tracking=browse_serp%3A6e7d0953-8f17-4f1d-a51e-3d9d1784e080

My local dump is called a transfer station and they guard their junk like it was gold. If you get caught taking anything you get banned. Nice find.

I p/u one of these inexpensive angle eyes from Ali. I have a box full of plug in transformers from various electronic devises, found one that output 12v and wired it up, I like more light. Thanks @slow-poke...

Gottcha, the feed drive uses the existing woodruff key to drive the shaft, I'll have to start lifting weights again.

I guess I could pull the Z axis shaft, lathe down cranking portion to 5/8" and then put a sleeve in the cranking handle in case I want to use it again.

Looks like they are trying to reuse the X axis feed to work for the Z axis as well, I would like to have a power feed on the Z axis too but the drive shaft on my mill is 11/16" and it's not a big mill at all. Hard to believe a Bridgeport mill has a 5/8ths Z shaft.

I stumbled upon this book today while hunting for some info, pretty basic for some of you guys but a good refresher for me. https://maritime.org/doc/pdf/machinist.pdf

I was just looking at those 3 drives not more than an hour ago, the 450inlb unit is in my cart.

Hear hear, it's kind of a special place, not many forums like this.