Search results

0.4mm :

The absence of a ground wire in older electric motors, whether single-phase or three-phase, is largely due to the evolution of electrical safety standards over the past several decades. Many motors built more than 30 years ago were designed before modern grounding requirements were widely...

Here's a photo walkthrough of how I use a stencil to set the solder paste... This is a laser cut stainless steel stencil, but mylar is a less expensive option. The squeegee is a credit card. You only need a tiny amount of paste, and it is quite sticky so the tiny parts tend to stay in...

Same invoice for my subscription. But yes, if you are a registered student with a school ID and StudentID and an edu email, you may qualify for the edu discount. Note that it is for one year only and must be renewed using the school credentials. At UFV the faculty had a site license that the...

Thanks for that! This would be a deal for a new user or someone currently paying monthly. I doesn't apply to renewals - but the kicker is that the new subscriber is locked into their $915/year renewal price after the first year.

I'm looking on the Autodesk/F360 site and I see a price of $915/year. The autorenewal quote was $675 for F360 without extensions, but if they are offering the same for $457 its a no-brainer. So just wondering how you found the discount coupon?

Where from ?? I need to renew next week. $675 was the quote.

Yes, but... there is a tool standoff as well - i.e. the shank must stay clear of the end of the edge because it would run into a wall. The chamfer toolpath will have a setting for that, the value is usually 1/2 the tool diameter, but if you are using the upper part of the flutes, the shank...

I think the surface effect is intentional - to add friction for the clamp and "knurled" knobs

Rustoleum Hammered. Its hard to find these days unfortunately.