Search results

But he should allow people to layout designs with more than etch-a-sketch and one drafting triangle! Batman …. No….Joker …pretty sure! Hahaha

Fugly

There ya go @architect : For my table (42”) I am using a 900 mm scale (35”) with the reader it is about 40” total length. It is secured on the back of the table (just below the table coolant drain holes) and the reader is mounted at the centre point of the scale to the base. You have a...

Or 30” - just make sure you can cover the full travel lenght

@architect - you need a longer longitudinal scale. Measure out the travel. I think you need like a 36” scale for that lathe

@architect - I believe your lathe is the 11/34 so you have additional carriage travel us shorter Utilathe guys have. I was looking at a DRO for Miss Metric as I will not be adding a taper attachment (lots of DRO space ;) ) Cross feed is about 7” so would need one 8” scale for that. My lathes...

I made the gear, shaft and a couple other parts for Matt. Not sure of his handle on here. He has all the original parts and he dropped off the full gearbox so I could make sure it all worked properly. The lower end gear works were very worn on his machine - certainly not in the same...

Sorry, late to the party…. I have this one: Works great, does lables and heat shrink lables - on black friday deal for $170. Mine has a case and charger etc.

Here are some pics of the complete gearbox re-assembly. The arrows on the last few pics indicate things to watch for and ensure are in the correct place for assembly

@skippyelwell - the #6 gear is a solid lump of steel and slides onto the drive shaft - held in place with a 3/16 woodruff key I believe. I made it April 3rd 2022 here are some pics. I should have dimensions drawn up somewhere- I have a few more note books to check.