Recent content by molyknow

Yes I did. A bit of both. I purchased them from a dealer in Calgary called Allredi. It was very reasonable - I think I paid $68 for the replacement glass and 20ft of door seal.

Picked this thing up a few weeks back for $250. Gave it a bit of a clean, some new seals and a fresh piece of glass and its been awesome. My old unit (just posted for sale) was pretty good but this thing is on another level.

Clemco Blast Cabinet for sale. Extremely solid unit. Fully welded/sealed interior. Way better than the PA options of similar size. Will throw some glass bead with the purchase. Note: regulator and rolling base are not included. Also have some extra gloves for the unit. 200 OBO - Pick up in Calgary.

I don't know if its all locations, but ACT tools in Calgary has the KURT DX6 vise on sale for $985 + Tax. Not cheap, but beats out the KBC price by almost $100.

ACT TOOLS Great place for ordering cutting tools. Calgary guys are always friendly.

Browning V-belt pulley with a 1/2" finished bore, designed for 3L, A belt sections. OD is 2.2” More info from manufacturer below: I have 8. $8 each or make a deal for the lot. Located in Calgary.

I just found this https://www.kijiji.ca/v-power-tool/calgary/plasma-cutter-hypotherm/1706901640 Do you have a torch height controller? Did your machine have the CPC control port? ideally I don't want to have to buy a new torch

I'm fairly set on hypertherm as I already have a Hypertherm torch. Its going to be used on a CNC plasma table.

Giving this a bump. Would be interested in anything within Canada.

This was exactly what i was looking for and validated the decision to get a shars, deckel or high quality clone. I would like to get one of the 5c collet ones just because of the amount of work holding options available. Thanks!

Hi All, Im looking to buy a D Bit grinder. Some of the ones from Aliexpress and eBay cost about the same as the Shars/Grizzly options when you factor in shipping. Looking to get the opinions of other members who have already purchased one. TIA Alex

Hi All, Title says it all, I am looking to buy a Hypertherm Plasma Cutter. Minimum a Powermax 45 but let me know what you have. Ideally with it will have the CPC port installed, however that is not a deal breaker. Located in Calgary and open to anything in Western Canada. If you have anything...

If you are willing to sell the spot welder separately i would be interested

have you been happy with it?

I have used the starrett stuff which i believe i got from KMS, but a friend has mentioned the Dykem brans stuff is a lot better.