• Spring 2024 meetup in Calgary - tentative date Saturday, April 20/2024. Other regions are also discussing meet ups. If you want one in your area get going on organizing it! discussion
  • We are having email/registration problems again. Diagnosis is underway. New users sorry if you are having trouble getting registered. We are exploring different options to get registered. Contact the forum via another member or on facebook if you're stuck. Update -> we think it is fixed. Let us know if not.
  • Spring meet up in Ontario, April 6/2024. NEW LOCATION See Post #31 Discussion NEW LOCATION

Recent content by kevin.decelles

  1. kevin.decelles

    Back in the saddle !

    Another 70 days before I see the green stuff here.
  2. kevin.decelles

    Mill top of anvil flat?

    Yeah, I don't think my anvil is 'real'. way to easy to mark up.
  3. kevin.decelles

    Product Repairing a brand new PA lawn roller

    I’d repair it as the nearest PA is 2 hours away. I’d also email customer service to see if they’re kick back some money.
  4. kevin.decelles

    Tool Making Brushes and dryer tube clean outs.

    The rod material varies. I like the fibreglass ones for rigid pipe and the twisted wire ones for softer vent material
  5. kevin.decelles

    Tool Making Brushes and dryer tube clean outs.

    I use these on my pellet stove vents and dryer vents Dryer vent brush
  6. kevin.decelles

    WTB: 8x30 Knee Mill

    Confirming that 6x26 is too small?
  7. kevin.decelles

    Al casting advise needed

    Draft angle is a taper you apply to your pattern to allow you to pull it out of the sand without destroying your imprint
  8. kevin.decelles

    Al casting advise needed

    Where about in SE Sk? I may have some precasted blocks that would work
  9. kevin.decelles

    Okanagan here

    Welcome from eastern Saskatchewan.
  10. kevin.decelles

    KMS Makita mag drill sale

    i did aliexpress (vevor probably). 13 piece cutter set + drill delivered for ~500 two years ago. STill going strong. Use it a lot.
  11. kevin.decelles

    The Scammers Must Never Sleep

    It’s funny to watch my dad when he gets a call from one of these guys….. no computer, no internet, Flip phone, Pays in cash or cheque……. Basically 1970 lifestyle And then the calls saying they are Amazon etc start coming in….. man do they get ripped a new one especially if they interrupt...
  12. kevin.decelles

    Auction in Carstairs….. some interesting goodies

    I used to hate it when I was watching an auction and at the last moment someone here would post it and 100 of my friends (competitors) would get tipped off…. But since I’m in Saskatchewan this doesn’t count as bad! Machines, tooling, metrology Link to olds auction
  13. kevin.decelles

    Sovol SV06

    I don’t think I’ll ever go back . So much control, web UI, cameras , wifi…..
  14. kevin.decelles

    Sovol SV06

    I put Klipper on my Ender 3V2 and I can confirm the speed improvements. Over 45% faster overall. 13 hour prints happen in 6-7 hours now. Very nice. and print quality is vastly improved (using SuperSlicer).
  15. kevin.decelles

    Hello

    Welcome from 70km east of Yorkton. We have water and fire, thx for asking!
Top