Welcome from Qualicum Beachi!
The Victoria School District must have had some good equipment in the day
I have an Arboga gearhead drill press from Victoria High School and a Tom Senior mill from Lambeth High School
Located in Cobble Hill BC
Nice small machine for home workshop. No motor, no vise, no handles no tooling.
NMTB30 in horizontal spindle
Couldn’t tell about vertical spindle
Very solid apparently came from a local high school
Floor model but would need to go on a plinth for a comfortable working...
$100 for the adapter and all the collets(about 20 ranging up to 1”)
I think théy are size 3H. I also made a draw tube to go through the headstock to tighten the collet. You would be welcome to it as well. Located in Vancouver
Regarding the headstock taper, it could also be a 4 1/2 Morse taper. If it is you may have a tough time finding one.
If you are interested, I have a whole lot of Hendey collets and an adapter to fit a Hendey headstock. As I recall, the adapter is about 2/3 the length of a MT4/5 taper. If you...
I have that collet Chuck mounted on my Hendey lathe. It takes B&S 21 collets which are available in in round, square, hex and emergency sizes. I have never seen metric size collets but the round collets are available in 64ths increments.
Mine was made by KAR
The collets in the picture look very...
I have one for a Southbend. It is in storage now so may not be able locate it for awhile. If you don’t have any luck finding a stop I will get back in touch in 4-6/52.