Recent content by a smile

I think "double whammy" is a good illustration of my current situation. After I make a simple mistake, I inevitably get a more serious one. Because of repunching, I punched through the cable channel of the big drag board, which caused the control cable to break some, and re-purchased the cable...

I drew the finished outline using EDM and finished it up

I think I made a fatal mistake: positioning the tip of the cone without adjusting the verticality caused the center to deviate by 2mm

Last year, I added a cushion column to the tailseat, made of tetrafluoroethylene, which provides a soft cushion when the tailseat comes into contact with the large trailer. Why do manufacturers ignore the harm of such hard contact in their designs? Does your lathe tailstock have a rough...

Yes, if the forum can integrate an image preprocessor is the best choice, no matter how big the image, you can set the final upload size. Too bad I'm not a programmer.

机器已修复，生产过程的一些照片

Thank you for your comments! I think it is difficult for me to explain clearly, I have an internal retirement, basically no pension, so I am free, I can have time to do what I like, but because of the interference of other factors, I can not spend all the time playing machine tools. Let's just...

重建焊工小车

The iron red one is one of the 100 customized ones I found in the factory, and the thread is very poor, and the concentricity is also very poor, which makes me lose confidence. So I had to make my own screws and nuts. Then use standard mechanical screws to lock. My principle is that as long as...

In addition, 10 quick-change tool holders were made. All through profiles are machined using EDM lines What it looks like after cleaning This is my favorite color. The grinding machine is used to process six faces and, most importantly, V-slots.

I guess I probably didn't have enough space to take a full-size view of the machine because I didn't have a lot of space in my store. So, this is a full-size look I was looking for on the Internet.

Today, I suddenly found that many photos taken by mobile phones could not be read by PC. After Google query, I realized that the photo format after the current firmware 11 is HEIC format. This seems to add to some of the difficulties of reading the phone's photos directly. If it is not a very...

I use a YAMATO Muffle furnace, the original factory controller is broken, I am ready to replace a SDC36 controller. But I don't know how to write the control logic. Because the temperature goes up and down linearly. For example: when you need to heat up to 1200 degrees and maintain this...