Recent content by RodinPortHope

Thanks for this. I got 3 of the four from local supplier Peterborough Bearings ($327 CAD) and the forth , apparently an oddball is on order from from H&W Machine Repair and Rebuilding (hwmachinereapir.com) in Ft. Wayne IN. for USD$212 + so your estimate was good. They apparently come pre-packed...

I'll try him again tomorrow. Thanks

I spoke to them today. A very knowledgeable woman there said she'd look into it and get back to me but a snow storm was closing in and they were shutting down the shop early. Sounded like they were going to be able to suggest something.

Sorry for the confusion, and thanks for the reply. I have that manual. The part of the machine I'm working on is everything below that oil tank/reservoir. We just lifted the motor with that gearbox and reservoir off and went from there. So there is a long shaft, splined for a foot or so at the...

Can anyone direct me to a source for oil seals for this old mill. I just bought it and was told by its former owner that I'd need to replace an oil seal that separates the oil reservoir (just below the motor) from the moving parts below it. I take it that after I drain the oil out of it, I'll be...