Search results

I got a call from a friend last fall that he had a few dump trailer loads of logs for me for free. Last time it was all birch, so i loaded up and drove the 40km's to his place. I was all wet balsam. Man was i ever pissed.

I usually go fairly aggressive on the feed, 0.008" per rev or so, maybe 6-800 rpm on a 1.5-2" piece, and increase the speed a bit at the center, sometimes if finish matters. But either way, constant feed has always worked well for me rather than hand feeding.

Sure, but don't make a 2 hr trip

damn, i want that.

flip the power feed and let er rip.

Those appear to be in Wasaga beach, Ont as well.

If they are spur gears, I wouldn't worry about them until after you replace the bushings. Its probably a low pressure, low flow deal where clearances are much less critical. If the sides are chewed up, the housing will probably also require attention, which would then need wider gears to compensate

They don't take up much room. And you can hang stuff off them, just like most of the treadmills that seemed like a great idea at the time. I use mine once a month maybe, but nothing can replace it when i need it...just like every other tool. Great for sharpening stuff too.

I have annealed quite a bit of them in the woodstove. It goes from very hard to machinable pretty easy. Axles are a good source of material.

put an ELS on it and as long as its not super worn out, it'd be a decent lathe, and a good value for the money.