• Scam Alert. Members are reminded to NOT send money to buy anything. Don't buy things remote and have it shipped - go get it yourself, pay in person, and take your equipment with you. Scammers have burned people on this forum. Urgency, secrecy, excuses, selling for friend, newish members, FUD, are RED FLAGS. A video conference call is not adequate assurance. Face to face interactions are required. Please report suspicions to the forum admins. Stay Safe - anyone can get scammed.

SM 2000 series feed clutch adjustment

Darren

Darren

Ultra Member
Premium Member
Is it possible to adjust the clutch on the feed shaft? I can make it slip a bit more easily than I feel ok with. The manual doesn't say, but I know a few of you, such as @Brent H and @RobinHood have been into this model deeper than I have.
 
IMG_3194.png


The only way to ensure a good operation is to make sure the springs (5) and balls (6) are doing a good job. If the shaft slips a lot it could be the detent is worn on the gear (34)
 
It does feel like they may be worn, which would be odd based on the overall great condition of the lathe. I guess i'm going to have to pull it apart. On my Emco, the clutch is easily adjustable, and I was hoping for the same on this lathe.
 
You must log in or register to reply here.
Back
Top